Thermal behavior of alternative materials used as roof and efficiency of the reflective painting on the external face
DOI:
https://doi.org/10.17533/udea.redin.n82a09Keywords:
thermal efficiency, sustainability, bio-constructionAbstract
This study was developed in order to compare the thermal behavior of different types of roofs by measuring the External Surface Temperature (EST) and the Internal Surface Temperature (IST) over the days. The experimental design was completely randomized, with five treatments: AC - Asbestos cement tiles, BA -Bamboo tiles, BAP - Bamboo tiles painted in white, FB -Vegetable fiber tiles and bitumen, FBP -Vegetable fiber tiles and bitumen painted in white, with 15 repetitions, being adopted as repetitions the days of measurement. The temperature of the internal and external roofing surfaces was collected at 8:00 am, 10:00 am, 12:00 pm, 2:00 pm, 4:00 pm and 6:00 pm. Data were analyzed by SISVAR 5.1® program through the analysis of variance and Skott Knott test for comparison of means, significance level at 1%. The FB coverage showed the worst thermal performance compared to other types of coverage, with the best results observed in BAP coverage.
Downloads
References
C. Michels, “Análise da Transferência de Calor em Coberturas com Barreiras Radiantes,” M.S. thesis, Federal University of Santa Catarina, Florianópolis, Brazil, 2007.
C. Sampaio, C. Cardoso, and G. Souza, “Temperaturas Superficiais de Telhas e sua Relação com o Ambiente Térmico,” Engenharia Agrícola, vol. 31, no. 2, pp. 230-236, 2011.
F. Damasceno, L. Schiassi, J. Osório, R. Gomes, and F. Baêta, “Concepções arquitetônicas das instalações utilizadas para a produção avícola visando o conforto térmico em climas tropicais e subtropicais,” Pubvet, vol. 4, no. 42, 2010.
M. N. da Conceição, “Avaliação da influência do sombreamento artificial no desenvolvimento de novilhas leiteiras em pastagens,” Ph.D. dissertation, University of São Paulo, Piracicaba, Brazil, 2008.
S. Curtis, Environmental management in animal agriculture, 1st ed. Ames, USA: Iowa State University Press, 1983.
PINI, TCPO - Tabela de Composições de Preços para Orçamentos, 13th ed. São Paulo, Brazil: PINI, 2008.
S. Picanço and K. Ghavami, “Comportamento à compressão de argamassas reforçadas com fibra vegetal da Amazônia,” Rem: Rev. Esc. Minas, vol. 61, no. 1, pp. 13-18, 2008.
C. Kawabata, L. de Jesus, A. da Silva, T. de Souza, and L. da Cruz, “Physiological responses of caprines raised under different types of covering,” Engenharia Agrícola, vol. 33, no. 5, pp. 910-918, 2013.
J. Barnabé, H. Pandorfi, G. Almeida, C. Guiselini, and A. Jacob, “Temperatura superficial de materiais utilizados para cobertura individual de bezerreiros,” Revista Brasileira de Engenharia Agrícola e Ambiental, vol. 18, no. 5, pp. 545–550, 2014.
A. Panziera, V. Calil, F. Amaral, and A. Swarowsky, “Desempenho de diferentes tipos de telhado verde no conforto térmico urbano na cidade de Santa Maria, RS,” Disciplinarum Scientia, vol. 16, no. 3, pp. 445-457, 2015.
S. Brum, B. Almeida, E. Pelosi, J. Pacheco, and M. Guimarães, “Amianto: a bioética entre o custo e a toxicidade,” Revista Eletrônica Teccen, vol. 9, no. 1, pp. 52-56, 2016.
SAMA - Minerações Associadas, Crisotila. [Online]. Available: http://www.sama.com.br/pt/crisotila/index.html. Accessed on: Jan. 17, 2017.
C. Almeida, “O conhecimento sobre amianto detido pelos profissionais de saúde da Região Centro,” M.S. thesis, University of Coimbra, Coimbra, Portugal, 2015.
Eternit, Esclarecimento sobre a questão do amianto. [Online]. Available: http://www.eternit.com.br/destaques/institucionais/esclarecimento-sobre-aquestao-do-amianto. Accessed on: Jan. 17, 2017.
E. Almeida and R. Passini, “Thermal comfort in reduced models of broilers’ houses, under different types of roofing materials,” Engenharia Agrícola, vol. 33, no. 1, pp. 19-27, 2013.
X. Chen, L. Ma, and Q. Guo, “Tectonic Research of Sustainable Building Materials Based on Regional Perspective - Taking Wuyishan City for example,” Advanced Materials Research, vol. 689, pp. 407-413, 2013.
J. Guo, J. Tang, Y. Wen, J. Zhang, and Y. Li, “Development Status of Modern Bamboo Structure Building,” Applied Mechanics and Materials, vol. 351-352, pp. 26-29, 2013
A. Gatóo, A. Sharma, M. Bock, H. Mulligan, and M. Ramage, “Sustainable structures: bamboo standards and building codes,” Engineering Sustainability, vol. 167, no. 5, pp. 189-196, 2014.
A. Gupta, R. Ganguly, and A. Mehra, “Bamboo as Green Alternative to Steel for Reinforced Concrete Elements of a Low Cost Residential Building,” The Electronic Journal of Geotechnical Engineering, vol. 20, no. 6, pp. 1523-1545, 2015.
M. Sellers and N. Nawari, “Bamboo Fibre-Reinforced Composites for Tall Buildings,” Journal of Construction and Building Materials, vol. 1, no. 1, pp. 1-11, 2016.
R. Gomes, “Conforto térmico para aves em diferentes coberturas utilizando materiais alternativos,” Undergraduate thesis, State University of Goiás, Anápolis, Brazil, 2007.
L. Sarmento, R. Dantas, D. Furtado, J. Nascimento, and J. Silva, “Efeito da pintura externa do telhado sobre o ambiente climático e desempenho de frangos de corte,” Agropecuária Técnica, Areia, vol. 26, no. 2, pp. 117-122, 2005.
R. B. Vigoderis, “Ambiência e bem-estar em instalações zootécnicas - aplicações práticas,” in 1st Jornada Universitária da Unidade Acadêmica de Garanhuns, Garanhuns, Brazil, 2007.
D. Ferreira, “SISVAR: um programa para análises e ensino de estatística,” Revista Científica Symposium, vol. 6, no. 2, pp. 36-41, 2008.
H. Suehrcke, E. Peterson, and N. Selby, “Effect of roof solar reflectance on the building heat gain in a hot climate,” Energy and Buildings, vol. 40, no. 12, pp. 2224-2235, 2008.
K. Dornelles, M. Roriz, V. Roriz, and R. Caram, “Desempenho térmico de tintas brancas com microesferas cerâmicas para uso em coberturas de edificios,” in 11st Encontro Nacional de Conforto no Ambiente Construído (ENCAC) and 7th Encontro Latino Americano de Conforto no Ambiente Construído (ELACAC), Búzios, Brazil, 2011, pp. 1 10.
P. Abreu et al., “Análise termográfica da temperatura superficial de telhas,” Revista Brasileira de Engenharia Agrícola e Ambiental, vol. 15, no. 11, pp. 1193-1198, 2011.
A. Faghih and M. Bahadori, “Three dimensional numerical investigation of air flow over domed roofs,” Journal of Wind Engineering and Industrial Aerodynamics, vol. 98, no. 3, pp. 161-168, 2010.
R. Silveira, D. Marinoski, and L. Lamberts, “Avaliação da absortância à radiação solar e temperatura superficial de telhas de fibrocimento utilizadas nas coberturas de edificações do campus da UFSC,” in 14th Encontro Nacional de Tecnologia do Ambiente Construído (ENTAC), Juiz de Fora, Brazil, 2012, pp. 1166-1170.
R. Prado and F. Ferreira, “Measurement of albedo and analysis of its influence the surface temperature of building roof materials,” Energy and Buildings, vol. 37, no. 4, pp. 295 300, 2005.
K. Lima, D. Moura, I. A. Nããs, and M. Perissinotto, “Estudo da influência de ondas de calor sobre a produção de leite no Estado de São Paulo,” Bioeng., vol. 1, no. 1, pp. 70 81, 2007.
L. Zhu, R. Hurt, D. Correia, and R. Boehm, “Detailed energy saving performance analyses on thermal mass walls demonstrated in a zero energy house,” Energy and Buildings, vol. 41, no. 3, pp. 303-310, 2009.
A. Synnefa, M. Santamouris, and I. Livada, “A Study of the Thermal Performance of Reflective Coatings for the Urban Environment,” Solar Energy, vol. 80, no. 8, pp. 968-981, 2006.
M. D’orazio, C. di Perna, and E. Giuseppe, “A field study of thermal inertia of roofs and its influence on indoor comfort,” Journal of Building Physics, vol. 38, no. 1, pp. 50 65, 2014.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2017 Revista Facultad de Ingeniería Universidad de Antioquia
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Revista Facultad de Ingeniería, Universidad de Antioquia is licensed under the Creative Commons Attribution BY-NC-SA 4.0 license. https://creativecommons.org/licenses/by-nc-sa/4.0/deed.en
You are free to:
Share — copy and redistribute the material in any medium or format
Adapt — remix, transform, and build upon the material
Under the following terms:
Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
NonCommercial — You may not use the material for commercial purposes.
ShareAlike — If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
The material published in the journal can be distributed, copied and exhibited by third parties if the respective credits are given to the journal. No commercial benefit can be obtained and derivative works must be under the same license terms as the original work.
Twitter